Piller pods.
- Thread starter MrWilson
- Start date
deflanman
Active LVC Member
pillar pod
See my November 3rd post, "gauges installed on the A pillar." The first photos were my first effort; not good. But I reinstalled the pillar pod and posted new photos on 11-3.
See my November 3rd post, "gauges installed on the A pillar." The first photos were my first effort; not good. But I reinstalled the pillar pod and posted new photos on 11-3.
ONEBADMK8
Dedicated LVC Member
We made them for the Mark VII's of course lack of sales killed it and then there was no reason to move forward with the VIII's.
I would have loved to have made them for the VIII's but the VII's bareley sold their first runs.
I would have loved to have made them for the VIII's but the VII's bareley sold their first runs.
ONEBADMK8
Dedicated LVC Member
MrWilson said:
LMAO!!!!!!! Yes.
Yeah, i wanted to get a pod electric LED speedo and tach for the pass side, so people can see how im runnin, and for the passenger to poop themselves. Also i wanted tranny temp oil pressure and h20 temp on the drivers side.
MarkVIII93
Dedicated LVC Member
These are exactly the same as mark viii A pillars. Just stick some 2-way tape on them and drill some holes in the A pillar trim piece for the wires etc.
http://www.mn12performance.com/mn12parts/g_pods/g_pods.htm
http://www.mn12performance.com/mn12parts/g_pods/g_pods.htm
ONEBADMK8
Dedicated LVC Member
You can always do what Dan did then just blend it all in with flex filler. Looks smooth and clean, you just have to know what your doing and it will look real nice and clean.