looking for a thread

[topher5150]

There was a thread awhile back about a guy who replaced his u joints with out taking the shaft out. any help finding this would be nice.

 

[unity]

You should not need a thread, just replace then in place. Not hard at all, I've done it.

 

[kustomizingkid]

It was the guy with the WRX.... lol

 

[deadmark8]

ya know i tried to replace mine once...but found out i cant, cuz after 15yrs in WI they are seized in place and unless i get access to an impact hammer they are staying in there. but there's nothing wrong with them atm so its all good.

 

[topher5150]

found it. so i just push on one side pull opposite side out, rotate repeat