Load resistor..HELP!

[Eliot_Ness_Ls]

So I get my load resistors and I go to put them in but their's 2 wires on the clasp and 3 wires in the turn signal on the headlights.

Anyone (OWL MAN) think they can help as to which ones I need to tap this to?

 

[NYC LS8]

Google is your friend.

http://www.tuneshops.org/index.cfm?method=article&article_id=71

 

[Eliot_Ness_Ls]

Thanks, thats the same kit I got and the instructions are simpler than that and only show 2 wires but the LS has 3. I know what one is the ground of course but I cant figure out what color's the other wire is.

From the diagram I take it that its the middle wire and the ground wire?

 

[uknowmehfo]

Thanks, thats the same kit I got and the instructions are simpler than that and only show 2 wires but the LS has 3. I know what one is the ground of course but I cant figure out what color's the other wire is.

From the diagram I take it that its the middle wire and the ground wire?

thats correct middle and ground

 

[Eliot_Ness_Ls]

Gots it, THANKS!

 

[Eliot_Ness_Ls]

I hooked them up and they work but when I turn the lights them self on they dont work right. Without the lights on they blink normaly, but then they dont flash at all when I flip the headlight switch!

This is annoying and stupid, does anyone else use any LED's in the turn signals?