Stopsign002
Dedicated LVC Member
I want to restore my fog lenses. Havent had any luck searching on the forum. Anyone have a step by step/link to something I didnt find searching? Thanks
How to take out fog lenses?
- Thread starter Stopsign002
- Start date
hite337
Hite Performance
I think they have bolts on the backside holding them into the bumper.
Bullschmidt
LVC Photographer
Bookmark this site. It will be your best friend and save you a lot of time searching around if you don't have a paper copy of the service manual
http://deneau.info/ls/
http://deneau.info/ls/
Bullschmidt
LVC Photographer
Removal and Installation
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02 .
Remove the 3 nuts and the fog lamp.
Disconnect the electrical connector.
To install, tighten to 5 Nm (44 lb-in).
To install, reverse the removal procedure.
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02 .
Remove the 3 nuts and the fog lamp.
Disconnect the electrical connector.
To install, tighten to 5 Nm (44 lb-in).
To install, reverse the removal procedure.
Removal and Installation
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02 .
Remove the 3 nuts and the fog lamp.
Disconnect the electrical connector.
To install, tighten to 5 Nm (44 lb-in).
To install, reverse the removal procedure.
Wrong instructions for the '06. You need to remove the platform/bracket that holds the lights. IIRC, there are 3 or 4, 4 or 4.5 mm bolts. You will get a better idea once you're under there. Unplug the light and remove the bracket. The lights are held in by 4 bolts.
They are glass, so refinishing may be difficult. I replaced mine for <$80 shipped from Tasca.
Stopsign002
Dedicated LVC Member
Awesome, thanks for that website man. Definitely going to save me asking a good few questions lol
Bullschmidt
LVC Photographer
Crap I didn't even realize that. Those are the non LSE fogs. Weird since that manual is for the 06
Stopsign002
Dedicated LVC Member
Yeah I noticed that. I figure its probably pretty similar.
See my instructions above.
Stopsign002
Dedicated LVC Member
Nice thanks. Didnt realize they were glass. I guess Ill get some new ones at some point
Stopsign002
Dedicated LVC Member
Something to consider for the glass fogs;
http://www.ehow.com/how_2053620_remove-scratches-from-glass.html
http://www.ehow.com/how_2053620_remove-scratches-from-glass.html