Search results for query: *

  1. torquemonkey

    Camber out of spec.

    Swapped out the '92 factory struts w/ new KYB GR2s. Took the car into the shop for an alignment. Prior to the R&R, the right side wheel had a bit of negative camber. After the alignment the shop said the car is maxed out of adjustment. Front:Right Camber: Before -2.0 Actual -1.8 specified...
  2. torquemonkey

    Oil leak from inside of crank pulley!?!?!

    Good afternoon fellow enthusiasts! So there I was, under the '92 replacing what I think to be the stock balancer with it's bulging and cracked rubber. After I pulled the old part of the car, I found that someone had siliconed the inside of the balancer at the key way. I have been cleaning, the...
  3. torquemonkey

    AOD rebuild in the future...

    Can anyone guess what failed in the transmission? I saw needle bearings and what looks like part of a bearing housing? It resembles train tracks going around a curve. This explains why I couldn't get out of 1st gear. :cool:
  4. torquemonkey

    EGR valve stuck

    Anyone have the specs. on vacuum pull for opening and closing of the EGR valve? I want to make sure that I do not have a vac. leak somewhere. As it is now, I have @ 1" of pull at idle and up to 5" as I up the RPMs. I have looked thru the manual and have found EGR repalcement, I have yet to...
  5. torquemonkey

    Thermo cap radiator cap

    I was looking at a catalog and thought this would be pretty cool part to put on the car...$20.00 RADIATOR CAP WITH TEMPERATURE GAUGE "Measure coolant temperature at the neck of your radiator—it's easy and eliminates guesswork! Built-in calibrated gauge maximizes accuracy, simplifies...
  6. torquemonkey

    Drive shaft ~ u-joint rebuild

    Has anyone replaced all their U-Joints? I am on a learning curve With the rear center yoke (Double Cardan Universal Joint) with its "slinger" and "centering spring inside the ball stud yoke". I've found a "clicking/clunking" coming from this area and believe that I need to replace all the...
  7. torquemonkey

    Ford Techs and Gurus 8.8 C-clip issue

    So how does one remove the C-clip over the "S" spring in a Trac-loc carrier? So far I have removed an O-ring in the slot and the C-clip wiggles and jiggles in the cut out on the axel. (the axel has been pushed in all the way) I have bumped the spring to where it sits furthest out and should...
  8. torquemonkey

    Coil spring conversion

    Has anyone used or heard of these guys? :cool: http://www.suncoreindustries.com/lincolnmark7.asp
Back
Top