Search results for query: *

I was trying to do my pads today and the rear pistons will not go back in. I rented the tool and they spin but they will not go in far enough to go over the new pads. They just spin but are not going anywhere. If I get new calipers how do I go about getting the ebrake cable off the old one...

I just replaced all my front suspension and took my lower control arms off but reused them as they were fine. When I took it to get aligned they said they couldn't do it because I didn't have eccentric bolts for the LCA's. I just put the stock bolts back in. The body is slotted though I would...

So I put new poly bushings on my front sway bar and put new end links on with minimal problems. I went to do the brakes and wheel bearings and the wheel bearings would not come out so I went to take the knuckle out and the lower ball joints are seized into the lower arm, so I had to cut the...

My shifter is really sloppy and loose feeling on my car. I have not had the boot off to look at it yet. Are these a direct shifter mounted on the transmission or a linkage type? Do they make a short throw or a way to rebuild it? Also the previous owner had a new clutch an slave put in about a...

I searched but could not find any info on if I can turn off the easy entry/exit on a 2000. In the manual it says to go in the message center but my car does not have a message center.. I was hoping there was a way to turn it off. If anyone has any info I would appreciate it.