Search results for query: *

There's a 96 FS 2 hours away for $800... 132k The bags are slammed, the fuel lines got ripped off (tried to get it on a lift... FAIL!), there's dents and a little rust, and one tire is flat. I was thinking of swapping the interior, but it's that aqua blue... if it was black I would've done it...

Alert: Stupid question below! Does the rear end have a drain plug? I looked under there and couldn't seem to find one.... it might be covered in gunk though.

I have an issue with the drivers door latch - it only catches when you shut the door and the door is unlocked. Now when you lock the door and it's latched, it stays latched, but if you try to shut it and the door is locked it won't latch. So uh... what the heck is going on?

I need a set... PM me :)

Here's the diff I want to swap into my Mk8. 3.73s with a fresh trac-lock and all set up nicely. NO ABS ring... plus... I dunno where the ABS sensor would go. I could take everything out of the carrier and put it in the Mk8 carrier, but then it would have to be set up again... So am...

I'm thinking I should drop the crossmember and fix the rust on my oil pan and change out some sway bar bushings. What all needs to be supported when dropping the crossmember? Thanks!

My spring project is to swap in my 3.73 t-lock pumpkin. It's the cast iron version, but for a completely set up, ready to swap pumpkin I couldn't pass it up. Ever since I swapped my 99 Grand marquis trans in my speedometer has been at least 10-15mph off, 20 or so if I'm going 70+. I would...

Ok this isn't Lincoln related, but... The director of my old department wants me to fix his Ford Ranger. He's a well connected guy so I want to make sure I'm thinking correctly on the issue. The problem is that under braking the pedal pulsates rhythmically with the truck's speed. Since...

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=160365421153 Just pulled it from my mark 8 - it worked just fine. If you need it quick shoot me an offer. The whole assembly is included.

How can I make the power steering more enjoyable? Loop the lines going to the PS pump? Get a larger pump pulley? Get a manual rack? I saw there was a manual rack for MN12s.... I'm looking for more feedback that I'm being given from it.

I have a set up for auction: http://shop.ebay.com/alwayspennyauctions/m.html Seems like a good set - I only tried them out for a week or so - the rear stayed up fine and they held air.

So I am in the middle of converting to coils and I removed my rear shock. I burned out the old bushings. Then I come to find that the upper section of the shock (where the new bushings go in) it bowed out. I cut the section off so the mount itself is flat. Has anyone else run into...

So I'm in the middle of replacing my UCAs, LCAs, outer tie rod ends, and converting to a tokico coil setup. Every nut has come off without a hitch except my strut rod ones. I got the LCA off, but it took me an hour of slowly heating up the strut rod nut and cranking on my breaker bar until...

When I start my mark after its been sitting overnight I can certainly hear the cams for a few seconds after starting. Could this be the cam tensioners? Is there a way to quiet them easily? Would some auto-rx help this? I certainly don't want to damage my engine. Apart from this it...

Just got one from these guys: http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&_rdc=1&ru=http%3A%2F%2Fshop.ebay.com%3A80%2F%3F_from%3DR40%26_trksid%3Dp3907.m38.l1313%26_nkw%3D130300234047%26_sacat%3DSee-All-Categories%26_fvi%3D1&item=130300234047&viewitem= Tests out just fine - even as...

http://cgi.ebay.com/ebaymotors/96-97-Mustang-Cobra-DOHC-V8-New-OEM-fuel-pump-module_W0QQitemZ220420167802QQcmdZViewItemQQptZMotors_Car_Truck_Parts_Accessories?hash=item335210d87a&_trksid=p4506.c0.m245&_trkparms=72%3A1171%7C65%3A12%7C39%3A1%7C240%3A1318#ht_1563wt_1242 For a 96 cobra...

I'm looking at replacing the rear bushings in my mark. Mainly the control arms subframe and the diff mounts. Laurel Mountain Mustang has excellent prices on the kits, but will these bushings work? 1999 - 2004 Mustang Cobra IRS control arm bushing kit. $57.50 1999 - 2004 Mustang...

Anyone have a pic of what is in the trunk tray - and definitions/labels for each item?

So I was going to replace my trunk lock cover today only to find that the mounting points were all broken off the light bar! I was extremely careful removing it, but I bet the PO busted it. Anyone have a good one lying around?

Mines getting all cracked and :q:q:q:qty looking. Notice I don't have an embroidered lincoln emblem on mine... Are there any cars that are a direct replacement for the leather covers? Or do I have to go and find another Mk8 with a gray interior?