Search results

Delete

Delete

I used LED Strip in there, probably outlast the car. Use .5 to 1k resistor to dim it to your taste. led strip | eBay

"Some assembly required" Sorry.... Here, I'll do it; There was talk on this thread of converting the suspension to springs. I politely suggested using SC suspension and sway bar. The sway bar was mentioned because unlike the Mark rear sway bar, the SC one is solid. This will likely be desirable...

Thunderbird SC suspension/rear sway-bar !

IF the car is not a daily driver, there's something to be said for learning something new. I digress, pay MORE than $500 for a replacement transmission.

Quoting The Terminator from TCCOA: "The EPC solenoid and MLPS needs to stay with the PCM programmed for it. Later model transmissions switched from wires to a circuit board in the trans and would require a harness repin. Any 4R70W not from a FN10 or MN12 has an 8 tooth output shaft. 93-95 are...

sounds like an lca ball joint to me . .

Welcome. It has been a great business for me for 10+years to use. I know they give it to get more business, which they deserve IMO. I fixed many a ford/turbo mopar with their parts site....

RockAuto discount code 8477494476228064 will expire on August 5, 2018.

Interesting idea. Perhaps the ECU runs one coil in a 'high' digital signal and then the other coil in a 'low' digital signal. A positive bias versus a negative bias on a coil could affect the origination of the spark if it's a signal going from a median to a high or low output.

Hello, I am a FNG. This is the best board for these cars IMO, glad you are all here! I am an old Thunderbird fan, I have owned 6 of the mn12 cars. I bring some good knowledge of these cars, particularly chassis and transmission experience. I have a new car, 96. I started a garage here. 161,000...