Search results for query: *

  1. termin8r

    Need some technical assistance

    I figured the alternator vs computer due to low voltage, I figured the computer wasn't getting a good signal but idk, it just hits me weird it tests good but is at 50ish amps.
  2. termin8r

    I need your help!

    Your brakes are wearing because your caliper is sticking, you can grease the slides but if its been that long you need new calipers. had the same problem on my crown vic. Its super easy to do yourself even if you don't know the difference between metric or standard lol. You can tell by checking...
  3. termin8r

    common vacuum leak areas (p0171/0174)

    Had the same codes on my 97. Replaced the iac motor. fixed.
  4. termin8r

    '96 acting up in the extreme cold

    Coolant temp sensor and thermostat. Coolant sensor the computer is out of range the computer will dup fuel on start up to warm the engine, but once to operating temperature it will back off to normal fuel ranges. there are two, one for the gauge and one for the computer, u need the one for the...
  5. termin8r

    Need some technical assistance

    No on a load test the battery tested bad, it bottoms out on a load. alternator and battery were tested on an autometer handheld from work (oreillys) the handheld tells you if the reg diodes etc are functioning and what the amperage is all while the car is running.
  6. termin8r

    Need some technical assistance

    So the mark has finally started to act its age, new motor new trans built converted from air for starters. Here's the problem, I've had a check engine light on that registered bank 2 lean. I replaced the upstream 02 and it fixed the problem. The next day I goosed it at a stoplight to get out the...
  7. termin8r

    noob with first mark viii

    The controller stays off until its time for a lil side by side cruising lol. And i simply pulled the light out, dropped the bulbs out, and carefully by hand take a long flat screw driver and apply pressure against the amber peice towards the front of the headlight. Theres three legs holding it...
  8. termin8r

    noob with first mark viii

    No, no stall or gears yet but this winter will hold the time slot for both lol. Got a b&m shifter today tho im hoping itll work .......
  9. termin8r

    Gen 1 Cobra Bumper

    What size are your wheels and did it take any modding aside from any due to its stance? Im lookin for wheels for mine and i like this look but mines not near that low. And i beleive those are zeniks right?
  10. termin8r

    noob with first mark viii

    Sounds good to me. A missouri meet would be awesome. I go to yearly mustang meets in my other car and its enjoyable with a good turn out.
  11. termin8r

    flashing message center and eatc lights

    Only places it could really be is the headlight switch/dimmer, headlight relay sticking, or the multifunction switch. Most likely a multi function swith shorted inside the column tho. Had this problem in my 95 5.0 on low high beam changing. My lights inside would flash when turning on high beams.
  12. termin8r

    noob with first mark viii

    O and i forgot i pulled the amber corner marker outta the housing for the clear corner look.
  13. termin8r

    noob with first mark viii

    Hey yall, been lurking in the shadows a while looking for the perfect mark to buy, im a huge fan. Im a diehard fomoco fanatic and have a navigator and a couple stangs but always wanted a mark. I finally found the perfect mark and stole it for 2000 flat from the second owner! 97 lsc treador red...
Back
Top