Search results for query: *

Here is my problem, I have replaced my alternator with a NAPA unit. My original alternator was dead, I had it rebuilt and was getting over 16V out of it which was way to high. I decided to get one from NAPA and it is charging at the normal 14.5 volts. However I noticed as I am driving especially...

Does anyone have the lighting circuit diagram for an 2002 LS V8?? I was getting a bunch of bulb out messages on the message center when driving at night. However all the lights were working. I was able to read the control module with my friends scan tool and it said "low beam headlight circuit...

Well here it goes, I had a bad alternator I had it rebuilt and istalled it. I was getting over 16 volts out of the rebuilt one. I put in a new alternator and was getting the 14.5 which is normal. However it then shot back up to 16 volts for a few seconds and then went back to normal and has been...

OK, so I have the battery light come on a year after I replaced the alternator which was from Autozone. I had a well know rebuilder check it out and he said the coill and regulator were pretty much toast. He also stated to check the batterty because the alternator was so toasted. I put in the...

I was working on my car and had to remove it in an emergency situation. However my Air flow sensor wire was disconnected and triggered the check engine light. I have to get the car inspected and thats the only code I see with the scanner and all emmission monitors are in a passed state. I don't...

OK, i know you need a special tool to release the fuel line and I have it, however it's not blue but it is green and it is for 1/2 fuel lines as I have an 02 V8 LS. However I cannot get the line to release is there a trick, I know the use of the tool should be pretty straight forward but I don't...

Are they covered by a similar warranty like the 03???

I have an 2002 Lincoln LS with the V8. I need to do a coolant flush because I think two differnt types of coolant were added and it turned brown. My question is on the flushing, I assume there's the drain on the radiator, but any other place?? Also I was wondering if anyone has tried using...

I was changing the valve cover gasket today on the right side of the engine, everything was going good until I retightend the bolts. All the bolts were tightening nicely and I didn't force any of them. However as i was tighting the rear upper bolt it would not catch and kept spinning. All the...