Recent content by slowmark95

Sold thank you.

http://rockford.craigslist.org/cto/4482085715.html 173xxxMiles Runs and drives great $2000 Takes it

I am selling my SCT 4-Bank Flip Chip with paired Z4H0 ECU The chip has tunes with progressively more spark advance for higher octane fuels, adjusted shift points and Idle speed. Contains one fuel economy tune, and three performance tunes, and the stock tune. I'm selling because i'm...

Here is what I'm working with. The passenger side bulb/ballast burnt out tonight so this is with the drivers side+ fog lights on. The picture makes it look brighter then it is. Part of my issue may be the headlight aiming? Btw I have had 3 ddm ballasts burn out but I have had zero issues with...

There is also noticeable upward glare without much of a distinct cutoff line.

The headlights are awful on the first gens. Halogen housings hid housing they just flat out don't work. Even with a 55w DDM kit with a relay in the hid housings the output is terrible and the cutoff is laughable. What are others experiences with the gen one lights?

This is the defroster switch bulb. The blue part is a rubber cover over the incandescent bulb. Look at computer key for size comparison.

You may have difficulty finding a replacement for the small incandescent bulb in the defroster & traction control buttons. I assume that these are the same bulbs used for the hvac and the lighting control panel?

Im looking for a hitch receiver to mount on my 1995 Mark VIII. If you have something you think will work, send me a PM with price and condition. Thank you

Both mine are completely rusted thru where they bolt up to the rubber material. I have not noticed any negative side effects, so I don't plan on wasting my time replacing them.

I purchased a pair of mint LSC housings for I think about $150 shipped a few years back on a forum. I just don't understand why people are spending so much money on these. It's crazy!

Lots of good ideas here! Im having a difficult time finding mufflers with the center inlet/outlet or off-set inlet/outlet configurations. NoLimit was kind enough to offer me the stock parts from his car, so I may just go that route.

:D It looks like that's out of the question then. Is there a compact muffler that would fit where the resonator once resided? All I could find was a glass-pack.

I would have done that, but I tossed the stock mufflers.

Yeah I will simply hit the undo button.....should fix it rite? :rolleyes: But on a serious note, would a glass-pack type muffler even quiet it down?