Recent content by skizimus

I am having the exact same issue. What was the problem?

thanks awsome thanks Joegr

so i replaced the WSS measured the bad one and it was all over the place checked the new one before I put it in,, it was a stable value, dont remember what it was, but it wasnt anything around what were in those procedures I found, Like 50 ohms or something WT heck. but it was stable. put it in...

out of the army now, prayers and gratitude for you guys. God Bless

thanks kumba Thanks

yup

CHECK FOR SHORTED WHEEL SPEED SENSOR CIRCUITS • Measure the resistance between the suspect wheel speed sensor pins. • Is the resistance greater 10,000 ohms? Yes GO to E5. No REPAIR the circuit in question. CLEAR the DTC. REPEAT the self-test. E5 CHECK THE ABS MODULE OUTPUT • Connect...

checking the sensor (needing an O-scope for checking the sensor?) A square wave is an on off, unles there is an off set, but would still be obvious. could u use still use a multimeter, jack it up and spin the wheel?