Recent content by RedHotMark96

Sold

Sorry for the wait. I'll try to have pics up in the next few days. They are being stored in my gf's basement, which is an hour from me. I also have a set of Republic Ensign tires of the same size, unmounted, which I'll toss in for free if the buyer wants them. The ensigns have good tread...

I have a set of 10 spokes with nearly new General Altimax Artic tires on them which I need to sell. The 10 spokes don't look great, they are old and some of the clearcoat has peeled off, so I was using them as winter rims. The tires have just 2000 miles on them so they look and handle great...

Whereabout in Ontario is this car located?

Sway bar (and end links) has been sold. Regarding then computer modules, I'd like to keep them with the engine for the time being because I need to be able to prove car runs to keep it where I have it now. If someone wants the engine I can move the car sooner.

I'm parting out my red mark after an accident. Damaged parts are: Bumpers (rear scuffed, front gone), bumper support brace, side marker lights, one of the mufflers (LMS exhaust system), grille is gone, I think the radiator is cracked. The hood is cracked at the front. And the airbags are...

If I got a set of energy suspension bushings+brackets from, what would be the easiest way to mount them. Should I use washers above or below the frame? A 1 1/8 universal would come with brackets that would fit right? Would it be possible for me to file down the ford brackets by hand or would...

How big is the notch in the part that slides in? The brackets I have have a 1/8inch notch, but it looks like I need a 1/4inch notch.

The bar came with brackets, which didn't seem to fit, so I ordered new ones, but they are the same and also dont fit, unless they are supposed to just rest on and not actually slide over the frame slot.

Thought about it, but I don't have anything to do it with, and it looks like it would significantly compromise the structural integrity of the bracket.

My rear sway bar brackets rusted out and snapped off, but the new ones I got don't fit. I have an addco 1 1/8 sway bar. I ordered a new set of brackets, but the notches on the T slot aren't wide enough to slide onto the frame. There appears to be a reinforcing plate welded to where it...

I'm still not sure how much I want to sell this car yet, but if asking price is met I'll let it go. Its a Bright Toreador Red 1996 Lincoln Mark VIII with 115,000 miles. I have had it for 2 years now and put a lot into it. New Driver's side lower control arm. Coil conversion (stock ride...

If the fuel pump is electric wouldn't it either work fine or awefully? My car with tune up (minus pump) jmod, summer tires, cat back exhaust ran only a 15.0 at Milan last year, and last week I managed only a 15.48 at Lapeer! It got slower!

I'm looking for a grille and the chrome trim piece that is directly above the grille if anybody has one or any leads. I'm having a pretty tough time finding one. Thanks

Do you still have the grille?