Recent content by OU812IC

Those are my pics.... I don’t even have them. Lol

Never came through... I sent a message to you as well. There are a bunch but one came up we had 7 people on common. Hahaha

I have done it as well as the head cooling mod. I used the ON3 performance kit. To do it again... Go to eBay and search 4.6 HCM or crossover delete and you should get the fittings that go in the heads for $30 a piece or so. Not when you get your AN fittings to get one that can accommodate your...

Basically... suspend the engine and drop the front cradle/suspension. You can do a search on here and I know you will find a write up on it. Better change the pressure line as well. Change the gasket on the oil filter adapter, a little easier with the cradle dropped. Check your oil pan and...

Good luck. Mine took a dump. Hoping to have the motor back in by the end of July. If not I am going to turn it into a pig roaster...

For the short term you can loop/bypass the cooler.

I blew the motor up last Sunday. Not to pieces but I went in a run to tweak the tune after doing the 4k stall and it detonated one too many times. Ooops

I have had a couple myself. Everything above about covers it. Look towards Florida,SOCAL and Arizona for a nice rust free ride. There are a couple of Facebook pages that have some nice cars come up from time to time as well. If I were to buy again I would go to FB and keep an eye out. I have...

I have friends that work at a large Napa store, largest in the Midwest, carter is not what it used to be. They run a LOT of Delfi stuff for the professional shops. Back in the day as a tech we installed exclusively Carter. They seem to have lost their quality standards since then. I just did a...

If your not putting an SC on or Nitrous, a stock pump will be Perfect. Du

I have the aeromotive 340 LPH pump in my 98. I had to go to the junk yard and get a different hump for the pump hat. Others than that it was simple swap. No wire cutting, swapped the pins in the pump connector. I did drill a few holes in the pump assembly. I have pis on here somewhere. Du

Put a pump in it... The regulator is not your problem. If it was leaking fuel that would create the problem you see but it would also be leaking when you pulled the vacuum line off. Du

You will need the handheld of your choice, doesn't really matter until you go to data log. I have a X2 and X4. The X4 is more cooperative when tying in wideband data. You will also need a software license from SCT for another $350. At that point it will be similar to other software you have...

It has been a while.... Did 4:10s . Supercharger is in and finally tuned to near perfection as of this past week. I ran 13.1 with a 2.1 60'. This winter it gets exhaust and a stall. Stall is tbd at at the moment. Du

What color and year? I am by Kenosha. Du