Recent content by Mildstang

O yea don't get me wrong, I wouldn't mind having one myself. I changed out my clutch, pressure plate, drive shaft and rear-end gears, bearings, seals, all that stuff right in the front of my house, just using blocks and everything I could find to get the car up high enough, it was a pane in the ...

You right on that, being in an apartment complex someone will snitch on you, I'm sure. As far as the quick jack, looks nice, can handle the weight okay, but like pulling transmissions and things you only have two ways in or out, from the front or the back and then having a place close by to...

Yes a lift of some kind would be really nice. My younger brother has a nice pole barn with a two post lift which helps out a lot.

Well I'm not the street racer I used to be, turning 66 in a few days. I have 4.10 in my mustang now wanting to go back to 3.55. For my project 3.55 will do me good I think.

Yea I know what you mean. Saving up for the next purchase for changing out the open end to a limited slip and 3.55 gears then go for the inter bushings.

I found some at SupercoupePerformance.com, already purchased the upper/lower knuckle bushings and lowered sway bar ends. The inner/outer lower control arms will have to purchase a little later. They are well worth the price and should not be any problem for non air ride systems, but I will be...

Retired

Are you still making the rear lower control arm and Knuckle bushing kits?