Recent content by marc1961

  1. M

    200 continental no start

    Changed the fuel filter the same time I changed the pump,then I swapped out the pump driver module After I jumpered to pair of the pins that go to the module and got the pump to run,I was told after jumpering these pins and the pump runs then the module was bad,new one did not help!! Thanks for...
  2. M

    200 continental no start

    Yeah it is still depressed did not pop up Have power to the pump.,thanks I have now swapped out the crankshaft sensor Did not help
  3. M

    200 continental no start

    Hi Replaced the crank sensor($39 autozone) That was not the answer to the problem Perhaps it is terminal!
  4. M

    Just Purchased 98 Continental- Please Help

    Where is the fuel pressure sensor located?
  5. M

    200 continental no start

    Hi Swapped out the crankshaft sensor($39) Did not help at all New pump,pump driver module and crankshaft sensor to no avail!!
  6. M

    200 continental no start

    The pump should turn for a second or two to build pressure Mine just trys to turn just a part of a revolution took the pump back out of the tank and plugged it back up and set it in a two gallons of gas to hear the pump try to spin. Put a fuel gauge on the pump and it would only showed pressure...
  7. M

    200 continental no start

    hello did not think of the crank sensor! I did pour a small amount of fuel directly into the air duct work in the engine and the car did start right up and died again quickly. so it would be a good idea to change out the crankshaft position sensor with a new one is there a reliable test for...
  8. M

    200 continental no start

    Hi, I have a 2000 continental it Wont start no fuel pressure at the schrader valve Changed fuel pump Then changed fuel pump driver module,still pump will only turn about a quarter turn Wont spin the pump will pump if you run a ground to the black wire on the pump itself How might I solve this...
Back
Top