Recent content by linc249

So, picked up the LS from Ford today, Coil Drivers are burned out of PCM, PCM is bad and needs replacement. I take the car back to the original shop and service writer doesn't wanna have anything to do with it and commented the PCM wasn't warrantied b/c I turned down the misfire repairs (which...

Update to my issue... So, I dropped the car off at FLM dealership on 7/27 afternoon. They call me today 7/29 and are still diagnosing the problem, but are leaning towards the pcm being bad. A little history about this situation, 6/21 car is taken to independent mechanic and diagnosed w/pcm...

PCM replaced now misfiring engine Any luck yet with your situation? I'm having the same problems. 03 LS V6 120k miles, started to shift hard in reverse and 2-3, 3-4, pcm problem replaced with re-manufactured pcm. Transmission shifts fine now, but engine is now misfiring p0353, 355, 356 (these...

valve cover gasket dude, not a fun job on the v6

I was having an issue with my coils and when I replaced them, I covered them in dielectric grease, and have not had an issue since.

rockautoparts.com

Will a 69' 302 BOSS fit in an LS? I know I would have to rip out a lot of stuff but if it fits I think it might be fun...

so what happens now? :Bang so like what the hell happens now if ls aint gonna be continued? parts prices gonna go up??? ls and thunderbird are basicaly the same vehicles and both are gonna be discontinued.... so is it wise to ditch my ls for something else while i can still get some value out...

use premium!!!! yes!!!!!!!!! use premium fuel only!!!!!! when i got my ls i thought i could get away with just using regular, but for 2 weeks the engine was making a clanking noise that was very annoying, so i switched to premium like the manual and gas lid door say and my baby has been hummin...

hey, i do not know if other years previous or aft were affected, but i own a 03 ls and mine was doing a lot of squeaking when i would turn even at a complete stop, so i took it in to the dealership ( still under warranty) showed them the problem and they found out it was the rack and pinion that...