Recent content by Kenny

Wondering what is possible and what isn't. I really wouldn't mind just having the front door panels if that's easy. Steering wheel maybe but that idc so much about. Other than that would be the center console. I think that'd be hard because gen 1 has a handbrake but I'd like to hear from anyone...

So essentially I can tap into an existing fuse that only activates when the engine starts for the ignition line. Or am I thinking about this wrong.

Okay, but since the controller has an ignition line, would it only receive power when turned on if I wire that in? If yes, is there a wire I can use a run tap crimp on for ignition?

Right on, will there be power when the vehicle is off? I have an ignition cable on the controller but wondering if it's necessary as I'm not sure where to tie it in.

I found it. Is there something I should buy to attach the wiring or just wrap it around and put the cap back on?

This stud you speak of, is it in the engine bay or behind the wheel well covers? I am wiring up two fans 25-30 amps max draw per fan at full blast through a controller. Prior to reading this thread (thank God the idiot was banned) I planned on splitting the fan controller power off into two...