Recent content by jt351

Put gears in it first, put some 4.10 and you beat that caddy. A stock windsor won't have any more hp than you have now just a lot more torque and a lot of hassle. but to upgrade your heads and cam your computer will have to swapped over to mass air off of a 89-93 mustang.

Well I got lucky picked up a 02 LS for $2k with a a bad fan, but dealer had quoted something line 2800$ to customer. all it was, was a sheared off roll pin inside the fan motor, pulled 4 bolts and put a new roll pin put back in car and now I have a fan that works, feels good to outsmart a...

So if the solenoid is bad and everything else is good the fan should at least turn slowly when idling correct? I just picked up a 02 v6 LS fan no worky, no leaks. My guess is bad fan pump,cause I am not seeing any fluid movement in resovoir.

Sounds like the plugs arent the problem, why do you think they are bad???? Are there any burn lines down the plug, you know the outside where the wire pushes on to. If you are getting burn lines than your wires are bad, replacing the plugs are only temp fix until the wire skips again ruining...

I just did rear wheel bearings ins a audi A4 awd similar setup like a mark 8 but used Bolts that go to axle instead of a nut, The torque on it was 85ftlbs and turn 1/2 turn, 180 degrees, that was f'ing tight, I had to use a 5ft long pipe to get it there, kinda real tight.

The last mark that did what yours is saying its doing , the customer had just come from the dealer with a new lighting module and about 500$ bill and nothing had changed, I found a chaffed wires shorting to eachother in the drivers door, but everycar is different.

You put 3 sets of Motorcraft cop's on?? did you just change all 8 at any sign of miss, most oem coils last 80-100k miles so do you have like 300k miles on it or what, how are the valve cover gaskets, and what plugs are you using. If you had a missfire burn down a plug porcelin it will ruin...

damn, I just paid 250$ for one side used off of ebay a while back, dealer price is like 800$

technically there are 4 coils that fire 2 plugs at the same time. its just they package 2 of them together, On each coil you can reverse the pairs and run fine, cause they fire the same time. you can switch them anytime and would give longer plug life. cause have you ever noticed how one...

A trans cooler is mainly more needed for a higher stall converter, not gear change. Almost all the heat created from a trans is from the converter, and the higher numerical rear gear means less torque put on engine and trans therefore torque converter will stay locked up longer which equates...

try swapping coils around, like switch coil #7 with coil #5 if miss moves than you coil is bad, just because its new don't make it good. Also the miss causes the lean code cause there is unburnt air going to the exhaust, cylinder #7 is bank 2 coincidence, I think not. I replace aftermarket...

that is not a true test though. but if they did quit then I would say yeah its definately clock spring. it is common to just lose the part of the clockspring usually the airbag part, go figure the most life saving part.

Ususally the higher octane fuel will yield a higher mpg in a LS because it uses knock sensors, If the ecm detects detonation it lowers timing and therefore lowers your mpg. If you drive it conservatively you can run a lower octane fuel with probably no decrease, but if you really think about...

Get Motorcraft wires. If you want blue get wires for a 1998 mustang cobra, I think they are cheaper than the red mark wires the mark calls for.

WOW than I am going to have a few hundred people come back with bad bearings. I call BS. Maybe if you impact is weak as hell and not getting the torque high enough. The preload is set in these sealed bearing, you technically cannot get them too tight, but too loose will unload the preload and...