Recent content by Ford4Life

Professional diagnosis is why I have replaced all that I have so far. That is why I have turned to this website to get people who actually own the cars advice.

The rotors and pads are good. I am going to check that pad that was wearing uneven when I changed them and see if it is still doing it. If it is, I am going to replace that caliper. If something is messed up in the caliper I would think that it could cause the lack of pressure when I brake. I...

No, could a bad caliper cause this. When I changed the pads a few months ago I noticed that the left front was wearing uneven. I didn't replace the caliper because I had just bought the car and everything was working great.

It is pulling a really good vacuum. I am lost as to what is wrong.

I didn't remove or replace the rotors. There is no grease on the pads or rotors.

When I pumped the pedal it held pressure but there is still no stopping power. Could this be caused by purchasing a defective master cylinder? I have bought new parts before from Autozone that didn't work. Should the vac line going into the booster be pulling a vacuum when the car is on or only...

It happened gradually. I don't think it is the caliper. It is like there is no brake pressure but there is also no leaks.

Fluid comes out at each caliper. No air is coming out only fluid.

It is very severe. I wouldn't even consider driving it on the road right now. Is there any type of relay or something that would be causing one of my new components to malfunction? The check engine light nor the ABS light is on.

I did these things chasing the problem. I bled the master cylinder before putting it in, I bled the ABS module but I didn't cycle it with a scan tool, and I bled the brakes at the calipers. Would not cycling the ABS module after installing it cause this?

I have a 2000 Lincoln LS 3.9L. Recently, I have replaced the master cylinder, brake booster, anti-lock brake pump, and bled the lines. However, whenever I press down my brake pedal it goes straight to the floor. I have no idea what could be causing this. Please Help.