Recent content by Erdco

I've used it for years, never had an issue. I use it regularly in the fuel in three of my cars, and three trucks, I have used it on a couple older vehicles via a vacuum hose stuck in a can of it. The spray can kind is best IMHO for cleaning out carbon buildup in the upper intake, I have used...

Been there with the squeaking ball joints, the ball rides on a nylon disk and when the grease dries out they squeak and creak like hell. Also, it's gonna pop apart real real soon, I put it off for a month on a t-bird, bad mistake. Drove over a mild bridge joint on the interstate doing 70 MPH...

Yes, but from what I have been told the bottom end is the same.

From what I read in the engine assembly pdf.. Bed plate bolts must be center punched after being completely torqued. Center punched bolts must not be reused. I took a quick look at the ones in mine, appears the pyramid indicated ones are punched.

Cool, thanks oddball and 112LS. I did some more searching and found a post from 2015 that cleared up a removal few questions. Does anyone have any tips on the bearings? I did get an email back from one parts place, they said the bearings are color coded, since I don't have it out and apart...

Yes, like an old school V8.

I was reading over this thread " So far: 4.0L Jaguar S-Type bearings = 3.9L Lincoln LS bearings " and and am hoping someone can say if this holds true for the 2005 model 3.9L? I just picked up a 2005 LS Sport in really good shape, except... it has a slight rod knock. I pulled the front pan and...