Recent content by dirtbikekid

No, I sure don't, if you can tell me how to find this out, I will surely post it on here, thanks.

No guys, they didn't rub at all! I dont' have any pics on them on the car, as I mentioned we only had them on for a short time before she found a maxima she liked, sorry. I know they don't rub because we never would have left the store with this size if they were rubbing the car, a few guys on...

The tires! The lugnuts and locks will be included!!!!!!!!!!!!!

These would look good on you guys Lincoln LS cars,they are Panther Boost 20" rims mounted on Wanli 255/35/ZR20 tires, they came off my wifes's LS right before we traded for a maxima, the tires only have around 200 miles on them but they won't fit her new ride so we're selling them: Only asking...

Ttt

Another shot of the wheels & tires.

BanginLS- $975.00 plus shipping! This is a great deal!!! We traded the LS in and have no need for the wheels!

Nope, they ride fine. Have another friend with same size tires on this LS and his are fine too. The tad bit taller sidewall gives the car a better ride.

Buddylee you have mail!!

Here is a pic of the wheels: Email: Eric.Reed@suddenlink.com

I have a set of 20" Panther Boost wheels on 255/35/ZR20 Wanli tires with only 200 miles,these came off my wifes Lincoln LS before we traded it in this week. Take advantage of these at a low cost shipped to your door...

Will my custom wheels from my Lincoln LS fit 04' Nissan maxima, both are 5 lugs but bolt pattern may differ, thanks!

Thanks, how long of a job would you expect this to be? I have tools and a garage, looking for a timeframe and difficulty factor. AND on top on all this......hope this is my problem should I decide to tear into it. IF they diagnose it, would it tell them that there is an airleak somewhere, or...

IT was a couple of months ago when they did the work so they should still warranty it, I was wondering if I should mention this hose to them to keep from getting the run around on it being something else.

Guys, I am having the same problem, it actually didn't start this till the shop replaced the valve covers and tube seals. How hard is this hose to replace, or either they left something loose when they did this cause I'm sure they had to take of the intake to do all this work. I'm just worried...