Recent content by 1996mark8green

temp fix solved Just to let everyone know I had to get to work the next day and needed to get on road so I determined that the vent valve was stuck open then removed lines from front of drier ( now for the redneck eng) took three- three way Ts and conected with reinforced hose now i had 5...

any way to get air into the system? I have tried to rattle the vent valve and still nothing is there any other way to get air into the system . i have a tire compressor and could cut the hose but what would i clamp it to . iam in a motel parking lot with limited tools in md i know if i...

no leak evedint I looked for leaks and i hear none , I have air comeing to back but it builds no pressure if i take line off while pump is running it hisses quit loudlly then i can plug it off with little effort . the dryer seems tight enough ( OF COURSE IT MOVES A LITTLE due to only being...

My car has a problem its completelly slammed to the ground not a single airbag has air in it , it will start the compressor and pump but no air gets to the system it is like it is venting . It has done this a couple of times but now it wont seem to come back is there anything i can do i have to...

Been haveing a problem with my air suspention , started about a month ago was driving in rain storm and all the air in the front suspention went out , pulled over and after a bit it aired back up only to have it do it about 400 miles later . Then it did it the other morning again and then when...

problem solved Thanks for everyones input , but 67 hit it right on the money the front passenger side ht senser had come loose at the top and now that it is in place the car is back to the right hight , thanks again dave

Came out to the car yesterday and it is air-ed up as high as it will go , I cut the air compressor off , when you turn the car on with compressor on it runs and times out . looks like a 4x4 right now . Iam currentlly in oswego new york and its like 18 degress how can i fix this please help...

i also have one I have one also but couldnt pull it till april or may has 110,000 and runs good iam in michigan and car was wrecked would have to be trailered its black and a 93 only thing i still want is the driveshaft out of it

just a question did you happen to also get a lean condition on one bank if so check and make sure the diaghrams in the intake runner control valves are good and hold vacume mine failed on passenger side and gave me same code still have this problem havent located the vac pot on any board...

mine was a 1967 ford truck 460 4x4 with two holleys and 3 fuel tanks , you could walk under this truck with only bending your neck and had 36 total off road lights what a gas hog lol

i do I would sell it for 15.00 and 5 for shipping thanks dave

do you still have the gen 2 plates if so how much i really only need the controlers on back

feel so sorry for you people Well iam from grand rapids michigan area but so sad for me i have to work in southern calif till march i hate that iam going to enjoy 65 and 70 degrees days , no really i do feel for you and i did it at a hand wash car wash

problem solved ok well 6hrs after washing it i went out and abs is back and taction control is on thanks guys for all you thoughts

hood clearance would you know how much clearance i would need and could i space the k member down that far