Any chance of making these in bulk & selling them?
I doubt there is a big enough market to make them. , we are a small community where only 97-98 would need it. I installed mine today. I had to modify it and my motor to make it all fit. I shortened the plastic shaft on the motor by 1/4 inch because the drilled inset was not deep enough. on the metal shaft side I had to trim off 1/4 in length and file it down to fit into the hole. I ended up with a slight raised motor after mounting but will clear the dash. Once I finish I will test its operation. I may sell the other metal arm but it will need modified also.