Search results

  1. K

    HELP! Bleeding power steering pump

    I have searched and searched and can't seem to find the answer. I have replaced the pressure switch in the power steering pump cause it started leaking. Of course, when I replaced that I lost the fluid out of the reservior. I have filled the resorvior back up and need to know how to bleed the...
  2. K

    need help with locating expansion valve

    Can someone tell me where exactly the expansion valve is located so I can replace it along with the compressor and drier. Thank you.
  3. K

    HELP!!! Expansion Valve Removal

    expansion valve removal Hello, have you been able to get the expansion valve off yet and if so how did you do it. Also can you tell me exactly where it is located. I am in the process of installing new compressor. Thanks for any help.
  4. K

    not again, need help

    compressor clutch Ok, I have searched around and I can get a new compressor clutch kit for around $35 on fordpartsonline. How hard is it to replace just the clutch kit. Do you think it is possible that it is just a bad clutch.
  5. K

    not again, need help

    ac problem Hey, thanks for the help. I unplugged the connector that I believe went to the aux pump and the dccv. The plug was located under the 90 degree turn of the intake right beside the air dryer, is that correct. Put a new fuse in with plug unplugged and turned ac on and immediately...
  6. K

    not again, need help

    blown ac fuse Thanks alot, I didn't think of that. Where can I unplug the DCCV. At least that will tell me if it is the compressor or the DCCV. If it is the DCCV can it be fixed and if so is there a write up on it without having to search for the next few months to find it. Again thanks alot.
  7. K

    not again, need help

    2001 lincoln ls v8 ac is blowing hot air, I have done the self test both stored and active and nothing. The ac compressor is not kicking in, not even for a second like low freon. engine light is not on. and i found out that the fuse under the hood for ac clutch (i believe that is how it is...
  8. K

    oh no not again

    Man it seems like this pos is falling apart on me now. Well after just fixing my coolant leak and high fan speed problem (actuator) last week, I now have another problem that has reared it's ugly head. First of all, it's a 01 v8. Has started rattling sound coming from drivers side. Rattles...
  9. K

    Replacing the cooling fan pump actuator

    actuator Tom, Thanks for the input on changing the actuator. I used your exact instructions and it worked well. Took less than a hour and yes it also restored my fan to high speed operation. ;) Thanks for everyone's input on my overheating issues as they are now taken care off and for a...
  10. K

    overheating issue- need help please!!!

    overheating issues FIXED Got the thermostat housing replaced and fixed the leak.:D Also replaced fan actuator and FIXED the fan!!!:D No more overheating.:D
  11. K

    overheating issue- need help please!!!

    overheating issue I am not sure yet if it is the actuator that is causing my problems with the fan, although by doing some research on here it is likely. I found a very slow leak around the thermostat housing that is causing air in the coolant system which is my main concern right now...
  12. K

    overheating issue- need help please!!!

    overheating Ok, thank you for the info. I will check the fan operation out and see if I can figure out where the problem for it lies. Also I have found the problem with my coolant very slowly dissapearing. After doing a bunch of searching today and getting the motor warm I found a very...
  13. K

    overheating issue- need help please!!!

    overheating Ok, thank you very much. This is very useful info. I may have taken off the degas cap before when the bleeder valve was open so I went out this morning and tried it again making sure the degas cap was closed the whole time and I got fluid coming out the bleeder valve as soon as I...
  14. K

    Degas bottle and Bleeding Help

    Basically what I was getting at is the thing run hot, or at least the guage went up and showed it was close to it (fail safe mode). And then without doing anything at all to the car other than waiting a little while you then drove the car for days, or weeks, or months and it didn't run hot...
  15. K

    overheating issue- need help please!!!

    First of all, thank you for your input. Ok, I understand it is not normal to put a quart in every month. I was simply stating what the manual said which was that it need to be checked once a month and if you have to add more than a quart once a month then it needs servicing. I said mine went...
  16. K

    overheating issue- need help please!!!

    black Please why don't you stick your head up lincoln jealous's ass while he sticks his head up yours and you will both be better off.
  17. K

    Degas bottle and Bleeding Help

    all is well Glad to hear you got it straight, I wasn't trying to hijack your thread or anything, just trying to clarify a couple things as I am trying to figure this thing out tonight or in the morning early.
  18. K

    Degas bottle and Bleeding Help

    bleeding Should the degas bottle cap be off during the complete process except only when filling the engine tower you have to have the degas cap on then so the coolant don't just run back in the degas tank. Or does it not matter if the cap is on as long as you don't have to add any to the degas...
  19. K

    overheating issue- need help please!!!

    overheating issue :mad:Oh, come on man, damn. I am in desperate need of help here and tried to post what was going on and you put your 2 cents worth in and all you can say is "good story". If your trying to be sarcastic, carry your useless posts somewhere else besides replying to mine, and...
  20. K

    overheating issue- need help please!!!

    Ok I am in need of some desperate help asap as the ls in broke down. I have searched some of the forums and I know all about the issues with degas bottle cracks and other leaks. This is what has happened. About six months ago car wanted to overheat one night while idling while I was waiting for...
Back
Top