Search results

Have noticed my car rides lower than most after changing out my cut coils and factory shocks to a set I grabbed from a V6 at the wrecker...are the V6 springs a lower spring rate?

Ok so I have a cyl 7 missfire for a while now, only pops up after a bit if a drive (new plugs and coils so not that) and of course have a bank 1 rich/bank 2 lean that goes with it..but now an having a high rpm miss/starving issue (4500-5000 and up) looking thru forscan and my fuel syst I have...

Tried search..no luck. Can anyone tell me what size wrench fits on the hard line (pressure side) from the pump to the motor. Not the side on the motor but the pump side. Mine decided to loosen off and now I'm losing fluid and overheating. Sort term solution I want to snug it up but going to do...

So I apologize in advance if this has been gone over before, but I can't seem to find an answer in search, my advance track has been acting up, and the codes say primary/secondary transistor failure (see picture). Now my question is...will any abs pump from that gen (1), work. I'm guessing I...

So have not seen or heard of this failing before..what is this cooling piece called...had it blow today...first hot day of course

So took the LS out for a rip last night, felt a slight miss at idle, no cel. Felt fine after a drive, then started to get in to it and it would missfire like it was hitting the limiter in park and neutral...but while driving and at about 4500-5000 rpm...so my question is coils? Pcm? Still have...

Hey everyone. Scored almost a full, black interior out of an 02 for 125$!. Swapping it around...and I let the rear belt retract on too far and don't know how to get them out so I can bolt em in. You guys got a trick?

Any vin geniuses able to tell me what rear diff this mustang has in it by the sticker? Looking to pull a trac loc this afternoon

Does anybody know what bulb is used in the third brake light of our first generation LS has?

So had the EGR low flow code forever, changed the dpfe sensor...now no low flow code but dpfe high voltage code ..wtf...should I blame the sensor being faulty?

So to my best effort I cannot find these in any lookup, but what do they call the front subframe connectors on the LS?. And when we're they implemented? Because I pulled some of an 02 V6 and they bolt right up. But I need to put in my own riv-nuts for the subframe half. Tho now I come to think...

Any of you knowledgable ppl have a trick to getting at the back upper control arm bolt... without removing the degas bottle that is?. I really don't want to disturb mine

Well...the vpd must be bored, as I just got hit with a box 1 VI... Anyone have the suspension alignment spec. For a 00 LS?. . Well there goes my weekend.

Does anyone know where I can find, or a part #/ aftermarket replacement for the two "trees" that hold down the engine cover on a first gen V8?. I have used maybe a half dozen different ones by now and they either look right and don't hold it down...or hold it down but look out of place/like crap

So I grabbed this amp out of the rear of an 02 V6, just for fun. And when I went to go plug it in to the harness I realized I had 2 male ends that were the same. Now on my 00 the amp connection is up by the seat, where as the 02 had it a bit further back, by the seat release. This plug will plug...

Ok so I have read most of the current led threads...but I am having an issue I have not seen. My drl for some reason only work on one side...I know they work by putting the high beam on a low voltage...and the high beams both work ..and I just put in resistors today to stop the headlight code...

now i may be barking up the wrong tree but these 2 cause me irritation...anyone have these codes and what was the solution? ode: U1262 - SCP Data Link Fault Module: Instrument Cluster Diagnostic Trouble Code details SCP Data Link Fault Operator Action Run self test. All CMDTCs Fix all...

So..after hours of cross referencing, checking, triple checking..I believe I have a solution for those looking for a performance based ignition coil, that will fit under the coil covers, and is offered by conventional performance suppliers. Now I may be wrong as it is still untested, but uf553...

Well...I now know why not many run 20's on these beasts, my 00 ls V8 came with some lovely 20" DaVinci's running 245/35r20 run flats..except the rear passenger side...I now know why...today while out of town it popped... something wore down the inside treadwall, and sadly I have not had it up on...

This may have been done...I admit I did not search...this is a flow of consciousness idea...has anyone tried doing a remote coil setup?. Like how they take the gm ones off the valve cover...and pop em on the firewall...ideas?