Separate names with a comma.
You just said it received that info from the ABS module
Is it really so hard to just wear the belt?
Why would there be an output shaft speed sensor on a manual?
the PCV valve screws into that box, I would get a PCV valve and put it in while you are that far in.
Year? Mileage? Engine? But, It's most likely time to replace ALL of the plastic cooling system parts. Your main problem is probably the degas...
Any particular reason for deleting the EGR?
Could be failing or sticking expansion valve. If it's stuck open, it's only getting enough flow to function somewhat with the higher RPM's.
Without the code it could be low fuel pressure, (replaced fuel filter) all the way to bad cats. probably weak coils though.
V6, V8? What year?
Thanks Alax! The side lenses look great! To me, they don't even need to be polished or anything, just clean up the flash and install!
The only reason my '02 overheated was a stuck close thermostat and that caused the degas bottle to fail.
Does it stumble and die, or just shut off?
when I repaired my wiring damage from a small fire, on the harness side of the O2 sensor, at least on my '02 LS, there are two wires that have the...
Dupont trade name for R134-a is Suva, replaces the old DuPont trade name for R-12 (Freon). Also, on my '02 V6 the low side port is on the compressor.
If you think it was a wiring issue, I would have pulled the entire transmission harness out of the parts car and put that in. Cutting and splicing...
There is, you have about 3 inches or so before the radiator. It is tight, but can be done.
turbo 4 mustang is coming in 2015
No, that puller wont work, there aren't any holes to screw into, this is the one,puller, to use the puller, remove the bolt on the crank pulley...
I just replaced the crank pulley on my 02 V6, there is room without taking everything out, but it is tight. I rented a three arm pulley puller...
The balancer for an '02 V6 is around $75 from Ford, and no, it won't fit a V8