Search results

  1. slowmkviii

    98 Lincoln Mark Viii lsc help

    Yea many times. Easy job but for coils I like to stay Motorcraft If you need to do gaskets thats a bit more of a challenge just find a good write up Also check the gap on the plugs
  2. slowmkviii

    98 Lincoln Mark Viii lsc help

    Spark plug boots fail a lot and so do the gaskets keeping oil away from the plugs
  3. slowmkviii

    First time Mark VIII Owner - Frame Rust

    Start with another car Keep all the clean parts for spares
  4. slowmkviii

    Chasing Fuel pressure pulse damper

    Grab a used one
  5. slowmkviii

    98 Lincoln Mark Viii lsc help

    Did you use mercon v The accelerating on its own id blame the IAC valve Normally can be cleaned
  6. slowmkviii

    Cadillac Ats brembo upgrade

    I'm going to help marviiiedrea do this in the fall but until then search people doing it on there 94-04 mustangs
  7. slowmkviii

    What did you do to your Mark VIII today?

    Installed wheels but not one pic I do not approve
  8. slowmkviii

    Message center

    Its not hard to replace and if you don't have the evtm it will be hard to track down electrical problems
  9. slowmkviii

    Blown Head Gasket: Need Advice

    If you just want it to drive try blue devil or steel seal
  10. slowmkviii

    TORQUE CONVERTER

    I personally think 3800 is a good place But thats just my opinion Kirk ran 5k with 500 at the wheels
  11. slowmkviii

    What did you do to your Mark VIII today?

    At street machine nationals st paul
  12. slowmkviii

    ride height sensor

    Put a add in the market place If you have Facebook go to mark viii marketplace look for Carlos or bruce
  13. slowmkviii

    Low fuel pressure help on a Gen2 needed

    Not sure on the mustang one but a bad crankshaft position sensor or harness can prevent starting
  14. slowmkviii

    ride height sensor

    Whats the question?
  15. slowmkviii

    Wheels That Fit Mark VIII's

    First this thread is supposed to be known wheels/tires that fit Second the tires are a bit short. 245/45/18 is the same as stock height. The wheels should work but make sure the hub bore isn't to small
  16. slowmkviii

    Stock bags new controller

    He was probably 8 to 10 years ago I dont recall his handle though
  17. slowmkviii

    Lincoln Mark VIII Interchangeable Parts

    Most parts between a 96-97 cobra can be swapped. Both are teksid blocks. A lot of people put just the cobra intake on the mark. Both are 8.8 rear gears I have front and rear hubs from an 03 cobra so I run mustang wheels and cobra brakes
  18. slowmkviii

    Stock bags new controller

    Its been done but not sure there are any write ups done Kirk and another mn guy have done it
  19. slowmkviii

    Ongoing updates to the 1997

    Almost as good as ce trim just need to find one without any cracks or chips and put a high polish on it
  20. slowmkviii

    Ongoing updates to the 1997

    Put my ce seats in polished all the wood to a much higher shine like a ce
Top