Recent Activity

Activity stream for all registered members at Lincoln vs Cadillac Forums.

  1. sgrillak replied to the thread 2000 v8: exhausted & scratching my head.

    hey. thanks for dropping in. the fuel pump is fine. pressure at the rail during cranking is ~50 psi. i did the pinpoint test for the...

    Feb 27, 2017 at 2:25 PM
  2. joegr replied to the thread New LS Owner.

    I have heard that the aftermarket shocks are worse than worn out factory shocks...

    Feb 27, 2017 at 2:08 PM
  3. joegr replied to the thread **WTB** 4W4T-17B676-AAW (Side mirror switch).

    Hey, I had a very similar problem on my 04. First, one mirror wouldn't move in one direction, then more and more mirror movements...

    Feb 27, 2017 at 2:06 PM
  4. joegr replied to the thread Weird windshield wiper problem.

    Is yours a 1st gen as well?

    Feb 27, 2017 at 2:00 PM
  5. joegr replied to the thread 2000 v8: exhausted & scratching my head.

    It seems odd that it would shut down the fuel, but not the ignition. Are you sure that the fuel pump is okay?

    Feb 27, 2017 at 1:57 PM
  6. joegr replied to the thread Dash Cam Installation.

    No RAP, unless someone ran a new switched power lead from the DDM or the REM, or if the car was originally wired for THX nav. For the...

    Feb 27, 2017 at 1:35 PM
  7. theg1ft replied to the thread rear tie rod ends?.

    I found some class 10.5 nyloc with no flanges. What do the flanges offer that the nut and washer won't?

    Feb 27, 2017 at 1:12 PM
  8. Jeff Freeman replied to the thread Never knew I was a Lover of Lincolns.

    that guy says that the Lincoln sat for some years and the air bags and the air shocks were taken out. Plus a new radiator. no front end...

    Feb 27, 2017 at 1:12 PM
  9. Ricolove0122 attached a file to the thread Official LS Picture Thread.

    Next goals are.. Paintjob but keep the original color GT& Vogues Tires. Keep it Classy [ATTACH]

    20170227_115654.jpg Feb 27, 2017 at 12:06 PM
  10. ACDiecast replied to the thread Dash Cam Installation.

    Yes, a Kenwood DDX-9703S will be doing the viewing. Thank you, that should give ignition power with RAP until you open the door, correct?

    Feb 27, 2017 at 11:39 AM
  11. oddball replied to the thread Update: Head gasket/timing chain job under way.

    Yeah...... Depends on the design and material of the bolt. Yes, all bolts stretch. But, if it's designed to be tightened to nearly the...

    Feb 27, 2017 at 10:58 AM
  12. Rockbottom replied to the thread Lets talk about balljoints.

    "I am putting entire new moog parts ,ties, balls, arms, the works in a kit from moog for 337.00 parts. I will install them in my own...

    Feb 27, 2017 at 10:45 AM
  13. theg1ft replied to the thread rear tie rod ends?.

    Managed to use the hack saw to get one side off. Probably going to have to do the same on the other side. The wire brush is a good idea....

    Feb 27, 2017 at 9:49 AM
Loading...