Recent content by toddrs93

Na like I said I did a comp test and it was low, removed the gauge and put it in another GOOD cylinder which read fine. Then checked the cylinder a second time, and low again. Then removed it again and checked it again a third time and still low. Each time it screwed in just fine and my gauge...

Yea interesting engine. So last week when I checked it like I said I got 20psi on the two and then I always try to check a known good cylinder on the engine if possible to get a baseline and to verify my gauge is working properly. So I did that and I got 180psi on another cylinder in the same...

Hello, I am new to this platform but I am a mechanic who owns my own shop. I do mainly aftermarket performance stuff and I would like to maybe offer some performance packages for this car in the future. For now though I am jumping into an 02 LS V8 that looks like a blown headgasket. I found...

when the car is off the ground, generally if you grab the tire top and bottom and can feel play in and out, it is a wheel bearing. Side to side movement is usually a tie rod end, or a ball joint. Wheel bearings also will usually make noise that gets alot worse when you turn the wheel one way...