No, I haven't tried. They really need new lenses, one of them scatters the light more than you would like to see with a projector. I sold the Mark a couple of weeks ago and I have these left over along with some new tie rod ends.
Lens started to turn yellow after the first year I defluted them and for a quick solution I put a stock set of headlights in.
What I am selling is a pair of headlights with the projectors already in them and the hid bulbs. NO BALLAST. I used them to power up some hids in the factory...
Well let me tell you what- the factory housing with some 6000k hid bulbs put out much light then my projectors ever did. I am amazed with how much light I have now. Cant wait to really drive it and check them out at night. Makes me question if I want to make new lens for the projector setup I...
So its been a year now and the lens have turned yellow on me and I believe it is from the inside this time. So I am going to take on the task of making new lens for these but not sure when. In the mean time to hold me over, the other day while walking through the LKQ in Daytona I came across I...
That is the correct port. I have had problems on the last 3 accumulators I have put in my mark. I find I have to wedge a piece of wood on top of my fitting and under the aluminum hide above it to keep constant pressure on it while charging the system.
My left front sensor is shot and I can't seem to find a replacement. I can find the right front all day long though. Anyone know where I can find one or what it would take to make the right side sensor work on the left? I read somewhere that it could work but something had to be done and I...
I tried to pm you but your inbox is full. I need an abs sensor for LH Front. I assume that is the driver side. Let me know if available and if you can box it and drop off at the ups store I can send a shipping label.
Like a good Ford, my Lincoln is always keeping me busy!
Today I finally got the time and all the parts to fix the A/C... AGAIN! Its been holding me up from finishing up other projects so when I got finished up it was time to start on the fun stuff.
New KYB Excel G in all 4 corners as well as...
Before I buy any used car, I use this first. If only I knew about it before my north star Cadillac. Napa sells it also:http://m.summitracing.com/parts/oes-27145?seid=srese1&gclid=Cj0KEQjw2v2sBRCazKGu3tSFz64BEiQAKIE1hghmm4IbLqopHHFJKgyl6pi2tHGrBHjhO56TldbkA3QaAt6W8P8HAQ
I have already cut some off, I don't remember if it was one or 1.25 coils. I would love to have them tucked in just a little but at the same time I don't Want to bottom out my new coilovers/shocks either. I would be happy if the gap was less to but I want more. I am going go game another quarter...
I am about replace my rotors, shocks and coilovers but at the same time I want to take the car down some more but wasn't sure how far I could go before I run into problems. Besides that, I am sure some new M8 members would like to know too.
From what I have read (in recent weeks as I have been kicking this idea around also) you can purchase seats and use the mounting bracket for a Thunderbird. I have fixed my driver seat twice now with no more than one use before it fails. I may end up following the write up on using the TBird...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.