whats the best way to run some wires from the engine bay to the interior

Best way is to find a rubber grommet and stab on thru.If you need a hand remember I live right down the road and have been installing radios/alrams since 1986.

I run mine different then most. I run mine straight back on the passenger side and then over the top on the drivers side.

http://www.lincolnmotorsport.com/enginetop1.jpg

I usually run them like this.

http://www.lincolnmotorsport.com/matt1.jpg

http://www.lincolnmotorsport.com/matt2.jpg

where is one of those rubber things Im looking for one but cant find it

Look strait back from the e brake pedal, up on the firewall. Might have to twist to see it, but that's the one that I brought 4awg power wire through for my stereo.

I run mine different then most. I run mine straight back on the passenger side and then over the top on the drivers side.

http://www.lincolnmotorsport.com/enginetop1.jpg

I usually run them like this.

http://www.lincolnmotorsport.com/matt1.jpg

http://www.lincolnmotorsport.com/matt2.jpg




Not sure if that was what he was looking for, but thanks for posting the pics. I'm about to change my wires out and I like the way you did yours.

Look strait back from the e brake pedal, up on the firewall. Might have to twist to see it, but that's the one that I brought 4awg power wire through for my stereo.

About the same place I ran mine. Running from one side of the compartment to the other is a total waste of time/money/wire....IMHO....Sorry Geno. WAY too much work too.

Sorry if the pix are a bit cloudy.... :Beer

Daaaayum NM I didnt even read it right. LOL!

ONEBADMK8, your engine looks sick!

good pics

Daaaayum NM I didnt even read it right. LOL!

Early onset of Old Timers there Geno.....do you remember where you work???? :N