cadillac, cadillac cts, cadillac seville, cadillac forums, lincolns of distinction, forum, lincoln mark viii, Performance, parts, lincoln, mark viii, mark vii, lincoln ls, lincoln town car

Lincoln vs Cadillac Forums


(This is the forums archive - If you want to get back to the main site simply click the banner above and you will be taken to our homepage.)

Lincoln vs Cadillac Forums is the Ultimate Online Resource for Owners and Enthusiasts of American Luxury Cars. Feel free to browse through our archive - but make sure you make it back to our main site - Lincoln vs Cadillac Forums




Cadillac XLR : Cadillac CTS : Cadillac : 2005 Cadillac STS : Cadillac Forums : 2000 Lincoln LS : Lincoln Mark VIII : Lincoln Mark VII : Car Wax
Lincoln Town Car : Lincoln Air Suspension : Lincoln Continental : Lemon Law : Do It Yourself Car Repair : Lincoln vs Cadillac Forums : Mesothelioma



Back to the Archive Main Page


Pages: 1

throttle problems

(Click here to view the original thread with full colors/images)


Posted by: jp1212

I am new to this site, I am looking for help changing a throttle position sensor and EGR Pressure sensor. I have a '94 Mark VIII. I feel in love with the car awhile back and have since put 120,000 miles on (the car had 60,000 when I purchased it.)

Recently, I ran into some problems. The car was not accelerating correctly (bucking I guess you could call it) I had the codes scanned and it appears the two sensors I mentioned before are bad. At first I was not able to locate either of them on the car. Finally, I assumed the throttle position sensor had to be on the back of the throttle body. There is absolutely no room to remove the sensor without taking the throttle body off first. I took the bolts out, removed the vacuum lines, now I'm trying to take the throttle cables off, and fear I will break if I am going to have any success in removing them. If anyone can tell me step by step, or has pictures of how to remove the cables it would greatly help. Also, if anyone has information about locating or finding the EGR pressure sensor and or knows how to change it, that would also be appreciated.

Thank you.



Posted by: 94m5

COPY&PASTE*http://image44.webshots.com/44/2/42/...8OWhDVx_fs.jpg

Caption #1...this linkage simply snaps off of the ball stud on the TB linkage, just place a small screwdriver between the linkage and the cable end and push it away.

Caption #2... this simply un-clips off of the linkage also. If you look closely at it while its still hooked up youll notice the cable end slips over the stud and clicks down over it.


As far as the EGR pressure sensor goes.....If it's the one im thinking of, it's bolted to the back of the drivers-side cylinder head. (A little grey box with a rubber hose, and a wiring connector attached to it.) I would know for sure, but I left the ford manual at the garage..

Hope that helps.



Mike





vBulletin Copyright ©2000 - 2008, Jelsoft Enterprises Limited.
vB Easy Archive Final ©2000 - 2008 - Created by Stefan "Xenon" Kaeser

Mortgage Calculator:Free Ringtones:Mobile Phones:Personal Loans:Debt Loans